200W UFO High Bay Light – Pro | 20000lm | 120° | IP65

The 200W is the heaviest fixture in the range and the one made for genuinely tall roofs. 20000 lumens at 120° still reaches the floor with real intensity from 10 to 14 metres, which is the height band where most high bays quietly stop working and buildings end up over-fixtured to compensate.

Pushing 200W through a lightweight housing is not a viable design — the driver and the LED board simply run too hot, and the fixture fades or fails early. The oversized radial fin stack on this model is what makes the wattage possible at all, and it is the single clearest reason to choose it over a flat, cheaper 200W fitting for a building that runs hard.

At 455mm across it is substantial, so confirm your purlin or truss capacity before ordering in quantity. IP65 sealed against dust and moisture, 90–265V input for fluctuating supply, suspended from a steel eyebolt on chain or hook. Cool, neutral and warm white.

Ideal for

Large manufacturing sheds and fabrication units with crane rails
High-racked warehouses and distribution hubs
Aircraft hangars, bus and truck depots
Steel, cement and heavy engineering plants
Grain storage and large cold storage buildings
Large indoor stadiums and exhibition halls

Not the right choice for

Ceilings below 10 m — you will pay for light you waste and create glare at working level
Roof structures with limited hanging capacity — check the weight before specifying
Light-duty storage on a tight budget — the Reflector 180W covers similar height for less

Planning guide: at 10–14 m, space fixtures roughly 11–16 m apart, or budget one per 90–120 m² for general storage light. At this height, aim fixtures down aisle centres rather than over racking, and confirm mounting structure capacity first.

Specification Detail
Model No. UFO200
Wattage 200W
Luminous Flux 20000 lumens
Efficacy 100 lm/W
LED Type 3030, 1W
Number of LEDs 280
Input Voltage 90–265V AC
Beam Angle 120°
Colour Temperature Cool / Neutral / Warm White
IP Rating IP65
Dimensions 455 × 220 mm (dia × height)
Body Material Die-cast aluminium, full radial fin housing
Mounting Suspended — steel eyebolt, chain or hook
Recommended Mounting Height 10–14 m